路基工程质量检验评定表

路评-01表

Name of Subsection分项工程名称：石方路基 Name of Section所属分部工程名称：Subgrade Name of Project所属建设项目： Engineering Position(Chainage) Construction Unit: Consultant: 1、 石方路堑的开挖宜采用光面爆破法。爆破后应及时清理险石、松石，确保边坡安全稳定； Rock excavation should be by smooth blasting method. Shall promptly clean up the rock of danger, loose rock after blasting to ensure the side slope safe and stable. 2、 修筑填石路堤时，应进行地表清理，逐层水平填筑石块，摆放平稳，码砌边部。 Construction of embankment of filled aggregate: clean up ground surface, fill and compact rock layer by layer, lay aggregate flat and stable, trim edges. 填筑层厚度及石块尺寸应符合设计和施工规范规定： 填石空隙用石渣、石屑嵌压稳定。 Thickness of filled layer and size of aggregate block should comply with requirements of design and specification: space of filled aggregate to be filled and compacted with aggregate slag and chips. 上、下路床填料和石料最大尺寸应符合规范规定。 Size of filling material and aggregate of road beds should be in line with specification. 采用振动压路机分层碾压，压至填筑层顶面石块稳定，20t以上压路机振压两遍无明显标高差异； Compact layer by layer with vibratory rollers to the extent that the top aggregate is stable and no significant elevation difference after compaction with 20t or more roller two times. 3、 路基表面应整修平整。 Subgrade surface should be trimmed and leveled. 规定值或允许偏差Specified 实测值或实测偏差值Measured value or 质 量 评 定Quality value or permitted deviatioin deviation appraisal PercenAverage Inspected items tage of WeigScor Class I highway, Other type value, of 1 2 3 4 5 6 7 8 9 10 typical qualifiClass II highway ht ing highway cation(value %) Layer thickness and number of Compaction 3 compaction comply with Basic requirements SeriaInspel No. cted Items 1 requirement 2 3 4 5 6 7 Longitudinal elevation(mm) Centerline deviation(mm) Width (mm) ﹢10，﹣20 ﹢10，﹣30 100 监理意见Comments from consultant 2 2 2 2 1 1 13 Evenness(mm) Crosfall横 坡±0.3 ±0.5 （%） Compliance with design Gradient requirement Side slope 平顺度 Compliance with design Smoothness requirement Total: 50 Compliance with design requirement 20 30 外观鉴定Exterior appraisal 质量保证资料Quality assurance documents 工程质量等级评定Grading of engineering quality Person in charge of Inspection: Inspected by: Recorded by: Rechecked by: Date: Score deduction 减分Score deduction Scoring: Grade quality: